July 22, 2019

January 31, 2019

December 26, 2018

October 25, 2018

August 28, 2018

June 24, 2018

June 8, 2018

Please reload

Recent Posts

BIG RED Frame and Engine Serial Numbers

October 29, 2017

1/5
Please reload

Featured Posts

Raising the Bar

August 28, 2018

As I get older I think about things differently. Lately I was thinking about optimization in the shop. Yes the lifts are nice but there is always room for improvement. I’m a big believer that a comfort and organization will lead to a more productive shop with less mental and physical effort. I tended not to think of such things when I was younger. I would be on my back in the gravel driveway or bent down for hours working on things. I was much more resilient back then and could recover quickly. I still end up doing “field” work out of the shop and it lets me know how well I have it. Back to optimization. Ergonomics – I decided to raise up my workbench and welding table so I would not have to be bent over so much when I have to use them. I used some cinder blocks to accomplish this and so far so good. The next optimization was the tool selection on both lifts. I found myself going back and forth to the toolbox to grab new tools as a job progressed. I have been working on BIG REDS for some time now and figured I can do I lot with a few tools. These include wrenches and sockets of the following sizes 8mm, 10mm, 12mm, and 14mm. I was recently at a swap meet and picked up two sets of these tools – one for each lift. Again so far so good less trips to the toolbox and I have extra tools. I also got an Led work light. This provides more light and less heat as compared to the fluorescent work lights.  For me I will look to optimize as time and money permits –so far it has been well worth it. Please comment as to things you have done to optimize your shop.    

 

 

 

 

Please reload

Follow Us